Specifications

Web-based management
RS2-4R
Release 1.0 03/04
5.3 System
135
5.3.2 Defining the start configuration
With this dialog you can:
D set a restart configuration,
D load a configuration,
D save a configuration,
D enter an URL,
D view the ACA status.
U Restart configuration
In the "Load after reset" frame you can set the configuration with which
the system is loaded when restarting.
If you select default, the parameters are reset to the original delivery
state, with the exception of the settings you created in the Software,
Configuration and Network dialogs.
U Load configuration
In the "Load" frame you can
D load a local configuration,
D load a configuration from a file stored under the specified URL.
D load a configuration from a file stored under the specified URL and
save it on the device.
U Save a configuration
In the "Save" frame you can
D save the current configuration on the device.
D save the current configuration in a file under the specified URL.
Note: The status of the load, started by DHCP/BOOTP (see “Configure the
network” on page 144), is displayed in the selected option "from URL & save
local" in the "Load" frame. If you get an error message while saving the
configuration, one reason may be that loading is not completed. DHCP/
BOOTP does not finish loading until a valid configuration is loaded. If DHCP/
BOOTP does not find any valid configuration you can stop the active loading
by loading the local configuration in the "Load" frame.