Specifications

Web-based management
144
5.3 System
RS2-4R
Release 1.0 03/04
5.3.5 Configure the network
With this dialog you define the source from which the switch gets its network
parameters after starting and assign network parameters.
Fig. 55: Dialog Network parameters
V Under "Modus" you enter where the RS2-4R is to obtain its
IP parameters:
D In the BOOTP mode, the configuration comes from a BOOTP or
DHCP server on the basis of the MAC address of the switch (see
page 57).
D In the DHCP mode, the configuration comes from a DHCP server on
the basis of the MAC address or the name of the switch (see
page 61).
D In the local mode the net parameters in the switch memory are used.
V Enter the parameters according to the selected mode on the right.
V You enter the system name applicable to the DHCP protocol in the “Sys-
tem” on page 127 dialog, in the "Name" line.