Specifications

Web-based management
RS2-4R
Release 1.0 03/04
5.3 System
151
5.3.9 Configuring traps
This dialog allows you to specify which events trigger an alarm (trap) and to
whom these alarms should be sent.
D In the "IP Address" column, enter the IP address of a network
management station to which the traps should be sent.
D In the "Name" column, you can enter a name for each recipient.
D In the "State" column, you mark the entries which should be taken into
account when traps are being sent.
Note: Shaded table entries were carried out by other management systems,
such as HiVision, and cannot be changed from here.
The events which can be selected are:
D Cold Start: The switch has been switched on.
D Link Down: At one port of the switch, the link to the device connected
there has been interrupted.
D Link up: At one port of the switch, the link to a device connected there has
been established.
D Authentication: The switch has rejected an unauthorized access attempt
(see the Access for IP Addresses dialog).
D Chassis: encompasses the following events:
– Power Supply: The status of a supply voltage has changed (see the
System dialog).
– Signaling Relay: The status of the signal contact has changed.
– Stand-by: The status of the Redundancy Manager has changed (see
the HIPER-Ring dialog
“Configuring the HIPER-Ring function” on
page 168 ).
– AutoConfigAdapter: The AutoConfiguration Adapter, ACA, has been
inserted or removed.