Specifications

Installation and startup procedure
RS2-4R
Release 1.0 03/04
3.2 Device installation
39
Note: With non-redundant supply of the mains voltage, the RS2-4R reports
a power failure. You can prevent this message by applying the supply voltage
over the two inputs
or by switching off the monitoring (see “Proper
functioning” on page 139).
Fig. 3: Pin assignment of the 6-pin terminal block
V Pull the terminal block off the RS2-4R and connect the power supply and
signal lines.
+24 V (P1) +24 V (P2)0 V 0 V
Fault