Specifications

Installation and startup procedure
RS2-4R
Release 1.0 03/04
3.4 Basic settings
53
3.4.2 System configuration via V.24 interface
If you do not configure the system via BOOTP, DHCP, Hidiscovery protocol
or the ACA AutoConfiguration Adapter, then perform the configuration via the
V.24 interface:
Fig. 10: Flow chart for entering IP addresses
If there is no VT 100 terminal available in the vicinity of the installation
location, the IP addresses can be entered prior to ultimate installation. A
VT100 terminal or suitable emulation (e.g. MS Windows terminal) is required
for this purpose.
Note: The installation of RS2-4R is easier if you enter the appropriate IP
addresses for each
RS2-4R at your workstation. Even if only one RS2-4R is
to be installed, it may be more convenient to enter the IP addresses at your
own workstation.
Entering IP addresses
Connect the VT100 terminal
to the RJ11 socket
The user interface
starts after key press
Enter password
(State of delivery: private)
Enter IP addresses
under System parameter
End of enter IP addresses