Specifications

Installation and startup procedure
RS2-4R
Release 1.0 03/04
3.4 Basic settings
55
U Network mask (netmask)
If your network has been divided up into subnetworks, and if these are
identified with a network mask, then the network mask is to be entered
here.
The default setting of the network mask is 0.0.0.0.
The addresses are stored in a non-volatile memory.
After entering the IP address, you can easily configure the via the “Web-
based management” on page 119.
3.4.3 System configuration via HiDiscovery
The HiDiscovery protocol enables you to assign IP parameters to the switch
via the Ethernet.
You can easily configure additional parameters with the “Web-based
management” on page 119.
Install the HiDiscovery software on your PC. The software is on the CD
supplied with the switch.
V To install it, you start the installation program on the CD.
Note: The installation of HiDiscovery involves installing the WinPcap Version
3.0 software package.
If an earlier version of WinPcap is already installed on the PC, then you must
first uninstall it. A newer version remains intact when you install HiDiscovery.
However, this can not be guaranteed for all future versions of WinPcap. In
the event that the installation of HiDiscovery has overwritten a newer version
of WinPcap, then you uninstall WinPcap 3.0 and then re-install the new
version.