Specifications

Installation and startup procedure
RS2-4R
Release 1.0 03/04
3.4 Basic settings
65
3.4.7 ACA AutoConfiguration Adapter
The ACA is a device for storing the configuration data of a MICE, RS2-4R,
RS2-16M, RS2-../.., or MACH 3000 switch. In the case of a switch failure, the
ACA enables a very simple configuration data transfer by means of a
substitute switch of the same type.
You can transfer the current switch configuration onto the ACA and the flash
memory with "Save local configuration".
When you restart, the switch assumes the configuration data of the ACA and
save them permanently into the flash memory. Which data the switch takes
from the ACA depends on the setting in the restart configuration (see
“Defining the start configuration” on page 135).
You will find further information on operating the ACA in chapters “Update”
on page 223 and “Defining the start configuration” on page 135.
Setting Result
Local The switch takes all the data from the ACA
from URL The switch takes the IP parameters from the
ACA and the other data from the URL
defaults The switch takes the IP parameters from the
ACA and the other parameters from the
default settings
Table 5: Data transfer from the ACA after restarting