Programming instructions

28
© 2003 directed electronics, inc.
When you are ready to drive the vehicle:
1. Insert the ignition key and turn
it to the ON (not the START)
position.
2. Press the brake pedal.
While the vehicle is running during remote start operation, the
system will monitor the vehicle and will automatically shut
down the engine if the system receives any of the following shut-
down inputs:
➤ The brake pedal is pressed.
➤ The hood is opened.
➤ The shutdown toggle switch is put into the OFF position.
➤ The pre-programmed run time (12, 24, or 60 minutes) has
elapsed.
➤ Transmitter button is pressed again to start the vehicle.
note: If the brake pedal is pressed before the key is in the
ON position, the engine will shut down.