User guide

20 Operation
3.5 Startup
3.5.1 System Startup
If necessary, refer to the figures in Section 1 - Introduction to identify system components.
To power on the dispensing system:
1. Verify that the main power cable is connected to the main power inlet and the facility power
source.
2. Verify that the facility air is at the recommended pressure level and connected to the main
air pressure regulator inlet. Refer to 3.10 Adjusting Air Pressure.
3. Turn the main power circuit breaker to the ON (I) position.
4. Check the EMO button to see if it has been activated. If it has been activated, deactivate it
by turning the red knob counterclockwise until the knob pops out.
5. Make sure the interlock signal is not interrupted. Close the dispensing system enclosure if
applicable.
6. Press the ON (l) button on the front panel.
 The dispensing system should be in a powered-up state and the digital gauges and
green power button should be on. If not, make sure the power cable is properly
connected to the dispensing system and to an active facility power source.
3.5.2 Starting Fluidmove for Windows (FmXP)
The FmXP startup procedure assumes that FmXP is already installed on your computer and that the
computer is turned ON (l) and running Windows XP.
To start FmXP:
1. Open FmXP using one of the following methods:
a. In the lower left-hand corner of the computer screen, click on
Start > Programs > FmXP.
b. Double-click the FmXP icon
on the Windows XP desktop.
 When FmXP starts, it will check to see that all the Input and Output (I/O) devices for
the dispensing system are communicating properly with FmXP.