User guide

Operation 21
CAUTION! Do not press any keys or the touchpad while FmXP is starting unless prompted to
do so. If the FmXP Message 30416 - Dispenser Motor References Not Found
appears, click OK to Home the dispenser (Figure 3-1).
Figure 3-1 FmXP Message 30416
Figure 3-2 FmXP Main Window
2. The FmXP Main Window (Figure 3-2) will open.
3. Check to make sure the dispensing head is in the proper home position.
 NOTE If you receive any error messages, refer to Section 5 - Troubleshooting or the Fluidmove
User Guide or Online Help.
3.6 Positioning the Dispensing Head
When necessary, an operator can use FmXP position (jog) controls to reposition the dispensing head in
the X- and Z-axes. These position controls can be operated using the touchpad to click on-screen
buttons, or by pressing key combinations on the keyboard. Both methods are described.
 NOTE The following procedures assume that the dispensing system and computer have been
turned on and FmXP is running. Refer to 3.5 Startup.
3.6.1 Using the Touchpad
To operate position controls with the touchpad:
1. In the FmXP Main Window, click on Jog.
 The Position Control dialog box (Figure 3-3) opens.
 The Dispenser radio button will be selected, indicating that the dispensing head position
controls are active.