User guide

Operation 37
Figure 3-17 Production Window – Load Program
7. In the Production Window, click on Run and then click on the Run Production button
(Figure 3-18).
 The Run Window opens.
8. Load the workpiece.
9. If applicable, switch the heated vacuum tooling switch to the ON (l) position. Refer to
Figure 1-4 for the location of the switch.
10. Click on Go to start the dispensing process (Figure 3-18).
Figure 3-18 Production Window – Run Program
 NOTE Refer to the Fluidmove User Guide for programming instructions.
Current
Program
Load
Select
Program
Open
Go Button
Run Button
Run
Production