User guide

38 Operation
3.13 System Shutdown
Routine shutdown may vary depending on your particular requirements. However, it is recommended that
you incorporate the following procedures into your production shutdown routine.
3.13.1 Production Shutdown
To shut down at the end of a production shift:
1. Wait for the dispensing program to complete and verify that all motion has stopped.
2. Unload all workpieces.
3. If necessary, purge or remove and clean the dispensing valve as instructed in the
applicable valve manual.
4. Exit FmXP.
5. Exit Windows XP and turn off the computer.
 Make sure Windows XP completely shuts down before turning off the computer.
6. Turn the main power circuit breaker on the back of the system to the OFF (0) position.
WARNING! CAUTION!
Before performing any servicing or parts replacement, the system must be shut
down for service. Failure to do so could cause serious injury to the user and/or
serious damage to the dispensing system.
3.13.2 Service Shutdown
To shut down for service:
1. Perform a production shutdown. See 3.13.1 Production Shutdown.
2. Disconnect the main power cable and place it in a locked box.
3. Disconnect the facility air hose and place a warning tag on the main air inlet.