Technical information

15
Zoom Mode Set-Up
To choose a Zoom Mode press the Set-Up key (Fig. 7.9). The Normal Zoom mode (Fig.
7.10) means that the Hand Unit controls the
position of the zoom motor and this position
is shown on the zoom bargraph display. Limits can be set to the zoom range using the
Set/Reset keys.
The Video Zoom mode (Fig. 7.11) allows the MDR to control lenses with integral servo
units. In this mode, the zoom bargraph display indicates the
velocity of the zoom motor
instead of displaying the position of the zoom motor. Therefore, limits on the zoom range
cannot be set. A video zoom cable is required to connect the MDR2 to the video lens.
8. The System Menu (Fig. 8.1) reports the installed firmware version, scans for other FI+Z
systems operating in the vicinity, sets-up the operating mode for the LED’s that illuminate
the focus rings, and specifies the focus distance units ( imperial/metric).
Press the Enter key (Fig.1) to see the System Info screen (Fig. 8.2). Pressing the NETWORK
key initiates a scan of all HU3 channels. The Occupied Channels screen (Fig. 8.3) lists the
channels in use and their signal strength.
The Network scan function will only detect G4 devices; it will not detect Wi-Fi, Bluetooth,
frequency hopping devices, etc.
Press the Light soft key (Fig.8.2) to display the options for illuminating the focus ring.
The Auto option turns on the light automatically under dim conditions. The options may
be selected by using the Nav key to highlight the desired choice.
The Region key (fig.3, 4) adjusts the output power of the microwave link to comply with
local regulations.
Fig. 8.4 Fig.8.5 Fig. 8.6
Fig. 8.1 Fig. 8.2 Fig. 8.3
Fig 7.10
Fig. 7.9
Fig. 7.11