Specifications

D-1

D Buep 19e-Direct driverD Buep 19e-Direct driver

D1 First commissioning

Preface The successful parameterization of the PCS as described in the PCSPRO

manual is presupposed. This appendix relates exclusively to the use of

the PCS 900/950 together with the BOSCH PLC by means of the

BUEP19E protocol. In the following, this controller is referred to as PLC

and the driver to be loaded into the PCS as B19EDIR. The BOSCH specific

terminology and the programming of the PLC with the BOSCH software

are presupposed as known.

Attention!

Use only the software PCSPRO or PCSPRO

WIN

for programming. Other

software packages can release failures of the PCS and PLC.

Required devices and accessories The following products are required for the operation of a PLC with an

PCS (Systeme Lauer company):

1. PCS 900/920/950 operating console

2. The PCS 706 connecting cable for the PCS to PLC connection via

the TTY interface or a zero-modem cable for the connection via the

RS-232C interface

3. PCSPRO floppy disk with 5P90BUEP driver, version 2.4 or later

4. PCS 991/925/995 manual

5. PCS 91.BOS appendix including BOSCH handling software

6. Optionally: PG-MUX PCS 809.BOS for the simultaneous operation

of the programming unit and the PCS via one programming interface.

Furthermore are required (BOSCH company):

1. „PROFI“ software (version 3.3 or later), programming cable, and the

copy protection device for programming the PLC

2. CL500 rack (or other PLC supporting the BUEP19E protocol)

3. Power supply NT 3

4. Coordinator board SK 500

5. One or several ZS 500/501 CPU boards (with 32k or 64k RAM

module)

6. One or several I/O boards

7. Power supplies for the PCS console and Bosch I/O boards