Specifications

9261-7974 Issue 06
ESFIRECODER - Emergency Services Firecoder
Page 82
www.multitone.com
SECTION 10 – Compliance Information
EU: - This is a Class A product. In a domestic environment this product may cause radio interference,
in which case the user may be required to take adequate measures.
Installation Notes
This equipment has been designed to conform to the relevant EMC performance standards, but it may
be necessary to take additional precautions during installation, to ensure continued compliance.
Use only cables supplied, or suitably rated power cables and screened signaling cable. Where quoted,
do not exceed specified cable lengths.
Keep cable runs to a minimum, especially on the outside of buildings and do not unnecessarily route
wiring alongside cables from or through areas that are a source of interference e.g. heavy plant and
switch rooms, RF transmitter housings, without taking suitable precautions to reduce EM interference
coupling. Where necessary, use additional protection e.g. armoured trunking, surge arrestors,
especially on the outside of buildings.
Where any interference problems are observed, it may be required to fit additional filtering
components such as ferrite absorbers, or in-line filters. If such action proves to be necessary, contact
either Multitone or their authorised agents.
Connection of Power Supplies
Use only power sources specified, or supplied by Multitone. The use of another device will invalidate
any declared conformity for this equipment, if as a result it ceases to conform with those standards on
which conformity is based.
WARNING
Do not install / use this equipment in areas where explosive gases may be
present, or it may be exposed to liquids, strong magnetic fields, extreme
temperatures or strong sunlight.