Installation guide

1100 Series Key Fob Installation Guide Digital Monitoring Products
3
Replacing the Battery
The 1145 Series Key Fob reports a low battery condition by
automatically testing for a low battery on a daily basis. When
replacement of the key fob battery is necessary, a LOBAT message
will display on the keypad and require a Sensor Reset.
Observe polarity when installing the battery. Use only 3.0V coin
cell batteries, DMP Model CR2032, or the equivalent CR2032
battery from a local retail outlet.
1. Insert a small at head screwdriver into the slot at the key
fob end opposite the key ring and twist to separate the key
fob front and back sections.
2. Push and slide the old battery out of the holder in the
direction of the arrow to remove it. See Figure 3.
3. Verify the positive side of the battery is up.
4. Slide the new 3.0V Lithium battery into the holder and push
into place.
5. Snap the front and back sections back together.
6. Perform a Sensor Reset to clear LOBAT from the keypad
screen.
Sensor Reset to Clear LOBAT
1. Press 2 and hold for two seconds on the keypad.
2. Enter your user code if required.
3. The keypad displays SENSORS OFF followed by SENSORS ON.
Caution: Properly dispose of used batteries. Do not
recharge, disassemble, heat above 212°F (100°C), or
incinerate. Risk of re, explosion, and burns.
Battery Life Expectancy
Typical battery life expectancy for DMP Model 1100 Series Key Fobs is 2 years. DMP wireless equipment uses two-way
communication to extend battery life.
The following situations can reduce battery life expectancy:
• If a receiver is unplugged, too far away, or not installed.
Note: Transmitters continue to send supervision messages until a receiver returns an acknowledgement.
After an hour the transmitter only attempts a supervision message every 60 minutes.
• Frequent transmissions, such as pressing a button multiple times.
The following situation can extend battery life expectancy:
• Extend transmitter supervision time in panel programming.
• Infrequent button presses.
Figure 3: 1100 Series Battery Location
Battery
Inside Battery
Compartment
Key Fob Front
Slot
Push Battery
Edge to Slide
Battery Out
Insert Battery
with Positive
Side Up