Manual

WASHFOAMFILTER REPLACEFOAMFILTER REPLACEFILTERCARTRIDGE
Hold foam filter under running
water to wash. Ring excess cleaner.
water out of filter. Allowfilter to
dry for at least 24 hours before
replacinginfilter cartridge.
TOCLEANTHEAiRDIRECTORS
_ iiiiliiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
Clickbuttons back into place To remove Air Directors, rotate
to lockfiltercartridge inbase of 1/4 turn couaterclockwise.
cleaner.
Returnfoamfilter tofilter cartridge. Return filter cartridge to base of
Pull out and wipe with a dam
cloth to clean.
REPLACEDiRTCONTAINER
Dryand returnthe Air Directors
to the dirt container. Rotate
1/4 turn clockwise to lock in
place.
Return dirt container to cleaner.
Align slot on bottom of dirt
container with tab on cleaner.
Pushto snapinto place.
TOOLREQUIRED:PHILLIPSORFLATHEADSCREWDRIVER
WARNING:TOREDUCETHERISKOFINJURYFROMMOVINGPARTS- UNPLUGCLEANERBEFORECHANGINGBELT
ORBRUSHROLL.
TOREMOVEBELT
Laycleanerflat and flip cleanerto expose
nozzle base. Base should lay flat and
face up. To remove nozzle guard, use
Phillips screwdriverto remove the three
(3) screws. Arrows show location of
screws.
TOREPLACEBELTORBRUSHROLL
J
Pull and lift nozzleguardoff.
Lift and remove brushroll.
Disposeof old belt.
Slide belt onto motorshaft.
Place new belt in area of Rotatebrushroll manuallyto make sure belt is
brushroll without bristles, properlyaligned.
Reattach nozzle guard. Secure by aligning the three
(3) tabs in the baseslots.
Replace all three (3) screws
to secure nozzleguard.
9 10