Replacement Part List

6. Beam & Tank Assembly

1. Rotate the Jack Stand attached to the side of the Tongue

Assembly downwards into position by releasing the pin and

then securing the release pin.

2. Remove the Retaining Clip, 1/8 in. 2 and Hitch Pin, 5/8 in. x

6-1/4 in. 1 from the assembled unit (as shown below).

3. Slowly back the assembled unit up to the Beam & Cylinder

Assembly. Align the Tongue Bracket of the assembled unit to

the Pivot Bracket of the Beam Assembly.

4. Once the brackets are aligned, install the Hitch Pin 1 through

the brackets then install the Retaining Clip 2 into the

Hitch Pin.

Item # Part # Description Qty.

1 100131 Hitch pin, 5/8 in. x 6 1/4 in. 1

2 100132 R-Clip, 1/8 in., Fits 1/2 in. to 3/4 in. 1