Replacement Part List

23
Operating Instructions
WARNING: Read and understand the complete Operation
Manual before assembling or using this product! Failure
to comprehend and comply with warnings, cautions and
instructions for assembly and operation could result in serious
injury or death.
Do not permit children to operate this equipment at any time.
Do not permit others that have not read and understood
the complete Operation Manual to operate this equipment.
Operation of power equipment can be dangerous. It is the sole
responsibility of the operator to understand the assembly and safe
operation of this product.
Call our customer service department at 720-287-5182,
1-877-487-8275, or visit www.dirtyhandtools.com if you have
any questions or concerns about the safe operation of this
equipment.
CAUTION: Oil must be added to the hydraulic reservoir and
the engine before starting or operation.
STEP 1: Fill the hydraulic reservoir with oil. AW32 hydraulic oil
is recommended. Automatic transmission fluid can be substituted
used instead of hydraulic oil when temperatures are below 32°F.
Use only clean oil and take care to prevent dirt from entering the
hydraulic reservoir. Fill the hydraulic tank with approximately 5
to 4 gallons of hydraulic oil. Remaining fluid is added at a later
step.
ENGINE OIL RECOMMENDATIONS
Use 4-stroke automotive detergent oil. SAE 10W-30 is
recommended for general use. Refer to the SAE Viscosity
Grades chart in your engine owner’s manual for average
temperature ranges. e engine manufacturer recommends using
API SERVICE Category SE or SF oil. e engine oil capacity is
20 oz. for Kohler SH265 (22-Ton/27-Ton) and 40 oz. for Kohler
CH395 (28-Ton). Always check oil level before starting the
engine and keep level full.
!
DANGER
!
CAUTION