Replacement Part List
7
Operation
OPERATION OF THE LOG SPLITTER (Continued)
• Do not straddle or step over the log splitter during operation.
• Do not reach or bend over the log splitter to pick up a log.
• Do not attempt to split two logs on top of each other.
• Do not attempt to cross split a log.
• Do not attempt to load your log splitter when the ram or wedge
is in motion.
• Use your hand to operate the control lever. Do not use your foot,
a rope or any extension device.
• Do not move the log splitter while the engine is running.
• Never leave the equipment unattended while the engine is
running. Shut off the engine even if you are leaving the log
splitter for a short period of time.
• ALWAYS operate this log splitter from the “operator zone.” is
is the area behind the wheels and control handle.
• ALWAYS check for damaged parts before operation. Do not
operate until it is repaired.
• Do not use an extension cord longer than 25 feet. Minimum cord
gage must be 16. An undersized cord will cause a drop in line
voltage resulting in loss of power and overheating
• Do not allow one person to operate the valve while another is
positioning the log.
• Do not attempt to load your log splitter when the ram is in
motion.
• Do not use this product for anything other than splitting wood.
• Do not use improper accessories with this log splitter. Check
owner’s manual for recommended accessories.
• Do not modify the plug provided if it will not t the outlet. Have
the proper outlet installed by a qualied electrician.
• ALWAYS use a 3-wire extension cord with 3-prong grounded
plugs and a 3-pole receptacles that accept this plug.
• Do not loosen or remove the hydraulic ttings or the cap of the
hydraulic tank while the log splitter is running.
!
DANGER