Use and Care Manual

14
Trim Ball Assembly
Improper installation can cause damage to the trimmer bearings.
Follow directions carefully to protect the trimmer/mower from
damage. Assemble components in the order shown
(see figure 11.)
1. Place the spacer and bearing cover (with the lip facing up) onto
the sha (Figure 11).
2. Align the ats at the center of the plates with the at on the sha
and slide the line plates onto the sha. Ensure they are facing top
side up as shown.
3. Place the head of the trim ball bolt so it is sitting in the hex cavity
at the bottom of the trim ball.
4. Looking down at the top of the frame, hold the bolt head in place
with your nger and turn the trim ball counterclockwise to start
the bolt into the sha.
5. Insert the screwdriver as shown in Figure 10 and tighten the
assembly securely by turning the trim ball counterclockwise
when looking down on the top of the frame.
NOTE: When nished there should be no gaps between any of
the components.
Always make sure you remove the screwdriver from the head
assembly when nished. Failure to remove the screwdriver could
cause injury when the head assembly is engaged.
!
CAUTION
!
WARNING
Figure 11
LINE
PLATE
SPACER
BEARING
COVER
TRIM
BALL
BOLT