Replacement Part List

Storage

DO NOT STORE SNOW THROWER WITH

FUEL IN TANK INDOORS

Do not store in poorly ventilated areas, or near furnace,

water heater, clothes dryer or gas appliance.

1. For short term storage wait for the engine to cool, then

clean the engine with a clean cloth.

2. When the snow thrower is to be stored for longer than 30

days, prepare the engine for storage by emptying the fuel

tank and draining all fuel lines.

Note: As an alternative to draining the fuel system, a fuel

stabilizer can be added to a full gas tank. Do not

drain the carburetor if using a fuel stabilizer.

3. Run the engine until all the fuel has been consumed and

the engine stops.

4. Drain the carburetor (see Figure 28).

5. Clean out area around spark plug and remove. Pour one

tablespoon of engine oil into the cylinder through the spark

plug hole. Reinstall the spark plug, but leave the spark plug

wire disconnected. Pull recoil starter handle to distribute

oil in the cylinder. Stop after one or two revolutions when

you feel the piston start the compression stroke (when you

start to feel resistance).

6. Apply a thin coat of rust preventive oil to all uncoated

metal parts.

7. Cover and store in a dry, well-ventilated area out of reach

of children.

Figure 28

CYLINDER

ASSEMBLY

DRAIN

PLUG

WARNING