Product Manual

19
Maintenance
LUBRICATION
Gear Shaft
e gear (hex) shaft should be lubricated at least once a season or
after every 20 hours of operation.
1. Remove the lower frame cover by removing the two screws
which secure it (see Figure 13).
2. Apply a light coating of an all-weather multi-purpose grease to
the hex shaft (see Figure 14).
Wheels
At least once a season, remove both wheels. Clean and coat the
axles with a multipurpose automotive grease then reinstall.
Auger Shaft
At least once a season, remove the shear pins on the auger shaft
(see Figure 15). Spray lubricant inside shaft, around the spacers.
Also lubricate the flange bearings found at either end of the shaft.
Gear Case
e auger gear case has been filled with grease and sealed at the
factory. If disassembled from any reason, lubricate with two ounces
of new grease.
NOTE: Do not over fill the gear case. Damage to the seals
could result. Be sure vent plug is free of grease in order to relieve
pressure.
Chute Directional Control
Once annually, lubricate both ends of the chute directional control
crank with petroleum jelly, paraffin wax, or light machine oil.
Figure 14
GEAR (HEX)
SHAFT
Figure 15
SHEAR
PIN
SPACERS
BEARING
FRAME
COVER
Figure 13
COTTER
PIN