Instructions / Assembly

10
Wear gloves and use caution when handling the deck.
e blades are extremely sharp and may move
as you maneuver the deck.
Attaching the Remote Control to an ATV or other vehicle
1. Using a 13mm wrench or socket, loosen and remove the four
bolts, washers and nuts that secure the remote control unit to
the tongue (see Figure 4).
2. Using a 13mm wrench or socket, remove the four (4) bolts,
and washers that retain the pulley cover, remove and set aside
(see Figure 2).
3. Carefully pull the throttle and remote control cables through
the tongue to the desired length. ere is approximately four
feet of extra cable length beyond the end of the tongue which
permits attachment to an ATV, small tractor or similar vehicle.
4. For a permanent mounting, drill four holes to align with the
mounting brackets on the remote control. Secure the remote
control unit to a solid surface with bolts, washers and nuts
in four places. For a temporary mounting secure the remote
control with tiedowns.
5. Replace the belt cover and secure with the four bolts and
washers.
Note: Always mount the remote control within easy reach of the
operator’s position. It is not recommended to place the remote
control unit on a pickup bed or an unstable surface.
!
WARNING
Figure 4
Attaching the Remote Control to an ATV
REMOTE CONTROL
MOUNTING
BRACKETS