Instructions / Assembly

8
Unpacking and Assembly
Wear gloves and use caution when cutting and removing any
banding materials which may have sharp edges.
Unpacking and assembling the brush mower, which weighs 560
lbs., requires at least two people.
• Position the shipping container on level ground before unpacking.
• Wear eye protection when uncrating.
• Use caution when cutting the container’s banding.
• Use caution with exposed nails and screws when uncrating.
List of tools needed for assembly:
• Pry Bar • Metal Shears • Hammer
• Screw Driver • 17mm Wrench or Socket Wrench
• 13mm Wrenches • Gloves and Eye Protection
Whats in the container:
• Brush Mower • Tongue
• Remote Control and Cable
• Operation Manual • Engine Operation Manual
• Hardware Kit
Wear gloves and use caution when handling the deck. e blades
are extremely sharp and may move as you maneuver the deck.
Unpacking
1. Remove the top of the crate.
2. Remove the sides of the crate.
3. Cut the bands that secure the brush mower to the shipping
container. Cut the banding that secures the remote control and
cable to the tongue.
4. Attach height adjustment brackets with attached wheels using
hardware supplied (see Figure 1).
5. Raise the brush mower using the deck height adjusters
approximately 8 inches to clear the shipping block underneath
the machine and roll the mower off of the container base.
!
WARNING
!
WARNING
BRONZE
BUSHING
M10 LOCK
WASHER
M10 FENDER
WASHER
M10x20mm
HEX BOLT
Figure 1