Technical data

28
Central vacuum systems
Features of the electric power supply:
Be sure the section(diameter) of electric cables is
at least 2,5 mm
2
.
•
Mod. DS Super Compact
In the dust container of the central unit the following
parts are contained:
- 2 collars
- 1 tube Air for the connection to the vacuum
piping
The central unit can be installed on the wall or on
the floor.
When it is installed on the wall with the special
optional bracket for wall fixing (code IS90) please
take into account the minimal distances requested
(as in the drawing), in order to allow the reaching
of the dust container. Please see the instructions
in the mounting kit.
! WARNING !
In the case of wall installation we advise t install an
automatic shaker device.
Installation and connection
of the central vacuum cleaner
Stages for the connection of the central unit:
1. connect the tube Air 1 to the vacuum tube 2 which
is located on the back side of the central unit and
to the vacuum piping to the inlet valves 3, fixing
with a collar for the sealed connection 4 on both
sides.
2. if you want to install a breather pipe remove the
breather protecting screen 5 from the double lock
tube 6 by taking out the two lateral rivets 7. With
the optional rubber hose (code TE920) connect
the zinc tube 6 to the breather piping , by fixing
them with the help of 2 collars 4 on both sides.
3. remove the plug of the sockets 10 which is located
on the socket 111 and connect to the power main
12 V by paying attention to do the connection on
the grips 1 and 2 of the plug. Reconnect the plug
to the socket.
4. connect the plug 13 to an electricity socket 14
and the tension should be the same of that written
on the identification plate 15.
Please notice: the model DS Super Compact Turbo
4,5i needs the use of a differential circuit breaker
switch FI of the value of 300 mA.
2
10
6
9
15
7
4
3
12
4
8
5
11
1
13
14
Z 861
cm 50
cm 50
min.
cm
80
Z 860