User manual
10
5
. Single Master and Multi Master Modes
There are two ways to make copies using the
a
utoloader
:
Single Master Mode:
This mode requires that a single master disc is loaded onto the hard drive prior to initiating
the duplication process. This mode is ideal if your job involves one or very few master
disc(s).
Multi
Master Mode (Batch Mod
e):
This mode does not require you to manually
pre
-
load your master
onto the HDD
. Simply
place the master disc(s) on top of the
corresponding
stack of blank discs needed for that
particular
job
.
This mode is ideal if y
ou
have numerous master discs and few
er copies for
each master disc.
The Multi Master mode uses the Reserve partition to temporarily store the
content of
the
current master disc
for duplication purpose
. Once the task is
complete and
a new master
disc has been detected, the reserve partition'
s content
(of previous master disc) will be
replaced with the
content
of the new master disc.
You can tell immediately which mode you are in by looking at any of the Copy or Test menus:
The (SM) indicates
Single Master
Mode
, and the (MM)
indicates Multi Master
Mo
de.
For example, if you need to make:
5
copies of job A
6
copies of job B
7
copies of job C
Under Multi Master
Mode
, you would need to follow
the below
steps:
1.
Make sure
the
Input Spindle
is
empty.
2.
Place
7
blank discs for job C
first
on the input spindle.
3.
Place the master disc for job C on top of the
stacked
blank discs
for job C
.
4.
Place
6
blank discs for job B on top of the master disc for j
ob C.
5.
Place the master disc for job B on top of
the
stacked
blank discs for job B.
6.
Place
5
blank discs for job A on top of the master disc for job B.
7.
Place the master disc for job A on top of
the
stacked
blank discs for Job A.
Discmakers
X.xx
1. Copy
(SM)
Discmakers X.xx
1. Copy
(MM)