User manual

15
Discmakers X.xx
1. Copy (SM)
Choose Partition
[FUN.VEF] 4012MB
Counter:
No Counter
Preparing...
Please Wait
OK: 0 NG: 0 NB: 0
Input Bin > Drive01
Processing...
Please Wait
1.1.2 Start the Copying Process
Go back to the 1. Copy Menu. Use the Up or Down button to navigate to the following
screen:
Start the Copy Process. Insert your blank discs on to the Input
Sp indle and press the ENT/ Enter button to enter the 1. Copy menu.
You will see the Choose Partition menu:
Use the Up or Down button to find the partition where your
master disc is stored. Press the ENT/ Enter button to select that
Partition. Next, you wi ll see the Counter Selection menu:
Follow the instructions shown in Setting Counters on page 14 to
continue. Once the counters have been set, press the ENT/ Enter
button to confirm. You will see the Pr eparing screen:
After a short interval, the rob otic loader will pick the top disc from the
input spindle and place it into one of the drives . As this is happening,
you will see a screen similar to below :
This information screen shows what is happening. In this case, the
loader has taken a disc from the input spindle and is placing it into
Drive 1.
The loader will continue to remove discs from the input spindle and place those into drives until
either all of the drives are full, or the count that you loaded into the counter is reached.
It take s a few seconds for the autoloader to recognize all the discs.