User manual

34
System Utilities
2. System Info
System Utilities
3. Device Info
System Utilities
4. Load Default
Load Default
Press OK to Continue
12.2 System Info
The System Info menu provides a lot of hardwar e information about the autoloader such as
firmware versions, Duplic ation/Robot Control Boards type , etc . You can scroll through the various
specifications by pressing the Up or Down button.
Use the Up or Down button to se lect the System Info menu a nd
press the ENT/ Enter button to enter that menu.
12.3 Device Info
This menu allows you to see information about the recording devices built inside your autoloader .
Th is information includes, but is not limited to, manufacturer, model number, etc.
Use the Up or Down button to select the Device Info menu and
press the ENT/ Enter button to enter that menu.
12.4 Load Default
This function will reset all of the options back to the manufacturer's default set tings. You should
only perform this fun ction if your autoloader is acting ab normally.
Use the Up or Down button to select the Load Default menu
and press the ENT/ Enter button to enter th at m enu.
Press the ENT/ Enter button to load the de fault parameters or the
ESC /Escape button to re turn to the System Utilities menu.
12.5 Update Firmware
This function will update the software of your autoloader . To update, you need to insert the
manufacture r s Certified Update CD into the 1
st
tray and select this function by pressing the
ENT/ Enter button. We strongly suggest that you do not upgrade your autoloader 's firmware
unless your autoloader has become un stable or you are instru cted to do so by Tech Support.
Warning: When you update the firmware on your system , there may be a chance that yo u
will lose all of the data ( contents of master discs) stored in the user HDD partitions. Make
sure that you back up all of the data on the HDD before attempting this procedure.