User manual
40
Duplicator
2.
20
16.Shutdown
Shutdown
Press OK to Shutdown
Shutdown
Ready to Power Off
Input Bin Empty
Reset Hopper?
Drive 1
OK: 1 NG: 0 NB: 0
Access Drive Log?
If you run out of blank discs and the job is not complete, the autoloader will give you an opportunity
to fill the spindle:
Important:
When you add discs
to the input spindle, be sure to remove your finished discs
from the Output Spindle.
At this point you can either
load
more discs on to the input spindle
and press the
ENT/Enter
button to continue, or press the
ESC/Escape
button to terminate your project
.
Upon project termination, you shall see the
Access Drive Log
menu.
You can press the
ENT/Enter
button one more time to see the drive
log that indicates the number of passes and fails for every drive/tray,
or simply press the
ESC/Escape
button to go ba
ck to the main menu.
If you choose to see the drive log file, you will see a screen similar to
below:
Drive 1 indicates the below results are for the 1
st
drive.
OK: 1 indicates there is 1 successful copy made by this
drive.
NG: 0 indicates there are 0 bad copies created by this drive.
NB: 0 indicates there are 0 discs in this drive that were not
recorded due to non
-
recording error such as invalid media type,
etc.
Use the
Up or
Down
buttons to look at the drive log file for the
various
drives. Press the
ESC/Escape
button to return to the
1.Copy
menu
16
. Shutdown
This function will make sure it is safe to turn off your
autoloader
. Once you see
the
Ready to
Power Off message, you can safely turn off the machine using the power switc
h.
Turning off your
autoloader
without performing this function will increase the risk of damaging your
autoloader
.
Press the
ENT/Enter
button to enter into this menu.
Press the
ENT/Enter
button to shut down the
autoloader
. The
autoloader
will d
o all of its internal housekeeping and then display
a confirmation message:
Ready to Power Off
Press the power button to power off the system.