User manual

45
R176 Cannot detect disc in
drive tray
If error code 176 is shown, it represents that the picking arm is
attempting to remove a disc from a drive tray and canno t detect
the disc. This commonly occurs when the disc was removed
from the tray before the picking arm had an opportunity to pick it
up.
R192
~19 7
Disc mis s- loaded in
output bin #
If error code 192 ~ 197 is shown, it represents that a disc being
returned t o the output/ NG was not properly dropped from the
picking arm onto the output bin 0 ~ 5, respectively, where bin 0
indicates the position right in front of the drive housing.
R255 High static shock
error
T oo much static electricity built up from the disc ( s) . This error
occurs when the static electricity on the disc is too high. Either
the facility produces too much static electricity or the current
climate is conducive to high concentration of static electricity.
This error is caused by the buildup of an electric static charge
which shocks the robotic arm while loading a disc. If this error
should occur, the user must completely reboot the system by
turning the unit off at the power button. When the unit is turned
on again, it should operate normally, b ut you will need to
reprogram the job it was running.