Specifications

7. At the prompt, type fbulk and
press the “ENTER” key.
At the next
prompt, type fload and
press the “ENTER” key.
• You can now send software updates to
the NOMAD. In the HyperTerminal window,
click “TRANSFER”, then click “SEND TEXT
FILE”.
• Browse for the NOMAD upgrade le you
downloaded. Usually it can be found on your
Desktop, or in ‘My Documents’.
6. Turn on your NOMAD Controller and press
the “
* ” key [shift+8] on the keyboard within
3 seconds after powering the controller on.
The following screen will appear:
- If nothing appears, you have chosen the
wrong com port. Refer to Step 1 on page 24
and reconfigure.
- If you see ‘gain adjusted’ you have taken
too long to press the “
* ” key. Retry the
Controller power-up cycle again.
8. The file will then load, as indicated by
stars across the screen, as shown here:
• When the software has been loaded, you
will again receive the
prompt.
• Type default at this prompt, then press the
“ENTER” key.
Your NOMAD has now been upgraded!
Now, run a Test Dish in order to ensure
proper functionality. (See page 10 for steps
on running a Test Dish.)
26