Specifications

MOUNT CABLE CONNECTIONS
Connect the Control Cable and the NOMAD “IN” co-axial cable to the Mount
according to the diagram below which corresponds to your Mount.
*
When using the MotoSAT™ HD-DP3 in Dish Network
©
systems, this connection is used
as an input from an external dish. Do not use this connection to input to the NOMAD,
or to a satellite receiver.
†
Any output can be used as an output to the NOMAD, except as noted with the HD
DP-3 above. Default output to the NOMAD is Red.
FOUR OUTPUT CONNECTOR:
HD-SL5, HD-SC2
9-PIN CONTROL CABLE
OUTPUT TO NOMAD
†
TWO OUTPUT CONNECTOR:
Executive, MD500, MHDTV, MD1000.2, MSC60
9-PIN CONTROL CABLE
OUTPUT TO NOMAD
†
FOUR OUTPUT CONNECTOR:
9-PIN CONTROL CABLE
OUTPUT TO NOMAD
†
DO NOT USE! *see below
HD-DP3 DISH NETWORK
©
6