User guide

74
Controlling Other Components
Chapter 10
Checking the Device Codes
Use these steps to find the device code you’ve set for each of the remote control modes
(TV, DVD/BD or VCR, and AUX)
.
3 For AUX mode only. Press 0 for TV, 1 for
VCR, or 2 for an audio tuner or amplifier.
Then press the
STAR (*) button.
This step is for specifying the type of device that will
be programmed in
AUX mode. If you’re not
programming in
AUX mode, please skip to step 4.
4 Press the remote’s POWER button.
This puts your remote into code scanning mode.
5 Press the UP or DOWN ARROW
repeatedly until the device turns off.
As you press the
UP or DOWN ARROW, the
remote tries each code in its memory to see if it can
turn off your device. When the device turns off, you
have found a code that might work with your device.
Note: The mode button for the device will flash
rapidly eight times when you’ve scanned through all
the available codes for the specified device.
6 Press the POUND (#) button.
The device mode button flashes three times if you
have entered the code correctly, and saves the code
you found.
7 Turn the device back on and try some other
buttons to make sure that they work also.
Sometimes
POWER works when other buttons
don’t. If in Limited Mode (see step 6 on page 73),
also try
VOLUME or MUTE.
8 If necessary, repeat this procedure until
you’ve tried all the different codes and
chosen the one that works best with your
device.
You may need to repeat the scan to find the best
code for your particular device.
Note: This process could be lengthy, because of this
remote control’s very large device-code database.
Instructions Additional Information
1 Press and hold the mode button until
all the other mode buttons light up, and
then release the button. The device
mode button flashes.
For example, hold the TV button until all of the
other mode buttons light. When you let go, the
TV mode button will flash.