user manual

DISH

Receiver Setup for SK-1000

The following instructions assume that the TRAV’LER® antenna has found and locked onto satellites 110°,

119° and 129°. There should be an asterisk next to 110°, 119°, and 129° on the TRAV’LER interface.

The following instructions are based on a ViP

211 receiver. If your receiver differs from the options shown,

you may need to consult your receiver manual. The wording and display used in your receiver may

differ slightly.

If your receiver is showing a switch type of DPP1K.2, then a check switch test is

not necessary. In that case, skip to step 7 to complete DISH receiver setup.

If it is of any other type other than DPP1K.2, then check that there are no

checkmarks by SuperDISH or Alternate, and select Test.

Select option 1,

Point Dish.

Press Menu on

your remote.

Select option 6,

System Setup.

Select option 1,

Installation.

Press Cancel

four times to

exit the receiver

menu.

The receiver

setup is now

complete.

6 7

Verify that the

check switch

resulted in a

switch type of DPP

1K.2 and that there

is a green OK

status on Satellite

110, 119 & 129.

Select

Check Switch.

For Help, Call 1-800-788-4417

Winegard and TRAV’LER are registered trademarks of Winegard Company.

DISH and ViP are registered trademarks of DISH Network L.L.C.