- Dish Networks Receiver User Guide

Chapter 9
58
Sending Discrete Power On and Off
SENDING DISCRETE POWER ON AND OFF
Installers use Remote control discrete power ON and power OFF IR commands when
programming macro commands into universal remotes. Using an ON-only or OFF-only command
is more effective than a toggle ON/OFF command when trying to make sure the satellite receiver is
reliably in one state or the other. To use discrete power commands, complete the following:
TIPS
• If you don’t want to accidentally change channels on your TV or VCR, try programming the
remote control in Limited Mode as described on page 49.
• Be sure to put the remote control back in SAT mode whenever you’re finished watching TV.
QUESTIONS
• My remote doesn’t control my receiver or other components. What should I do?
– Put the remote control is in the correct mode (page 49).
– Check the remote control address (pages 47 and 53).
– Check the batteries (page 8).
381.book Page 58 Thursday, June 29, 2006 11:00 AM