User's Guide

Dish Technologies Battery Charger User Guide.

Model: NHGBC

The battery charger is design to be commercially installed.

Installation Steps:

1. Remove cover

2. Professionally install supply and load side wiring

3. Mount to Dish approved location

4. Install batteries and route cables to mainboard

5. Plug all mainboard connections in (supply, load and batteries)

6. Close cover

BLE Operation:

The BLE radio in the product will send beacons with encrypted status information.

Nearby Dish BLE sensors will receive the beacons and be able to decrypt the status information.

There are no installation steps necessary to configure the BLE radio for its intended functionality.

PAGE 1
Dish Technologies Battery Charger User Guide. Model: NHGBC The battery charger is design to be commercially installed. Installation Steps: 1. 2. 3. 4. 5. 6. Remove cover Professionally install supply and load side wiring Mount to Dish approved location Install batteries and route cables to mainboard Plug all mainboard connections in (supply, load and batteries) Close cover BLE Operation: The BLE radio in the product will send beacons with encrypted status information.
PAGE 2
FCC Statements: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.