System information

S7000 Series TV Analyzer Operation Manual
6
13) TAB key, this key is used to switch marker.
14) UP key, DOWN key, LEFT key, RIGHT key, the keys are used to move cursors and change the value within a
function display.
15) Keypad, these keys are used to enter alphanumeric characters.
16) Function soft keys, these keys are used to access various functions within the display.
1.3.1.3 Title Bar
Figure 1-2
a. TS-ASI indicator. It indicates that ASI function works when this icon appears on the title bar. Please see
Section 2: SETUP->INTF.->TS INTERFACE to get the operation,
b. CA indicator. It indicates that the instrument recognizes CA card successfully when this icon appears on the
title bar. And then users can run the TS Monitor & Analysis function. Please see Section 5: TS Monitor &
Analysis to get the operation.
c. 22KHz signal indicator. Users must run this signal when using DiSEqC. It indicates that the running is
successful when this icon appears on the title bar. Please see Section 2: SETUP->INTF.->LNB POWER to get
the operation.
d. LNB power supply indicator. It indicates that the instrument runs LNB power when this icon appears on the
title bar. Please see Section 2: SETUP->INTF.->LNB POWER to get the operation.
e. GPS indicator. It indicates that the instrument recognize GPS module successfully when this icon appears on
the title bar.
f. LAN connector indicator. It indicates that the instrument connects the LAN line successfully when this icon
appears on the title bar.
g. USB connector indicator. It indicates that the instrument recognizes USB successfully when this icon appears
on the title bar.