System information

S7000 Series TV Analyzer Operation Manual

2.1.5.5 Satellite List

Before attempting to use the SATELLITE function in S7000, user must edit the desired satellite list. Once

completed, this will allow S7000 to measure all the satellites automatically and save the various measurement

data.

Select keys (UP/DOWN) and key (ENTER) to enable the satellites you wish to add to the Satellite List.

(To disable a marked satellite, select key (ENTER) again.) Select ENABLE ALL to enable all the satellites and

select DISABLE ALL to disable all the satellites (except current satellite).

The ‘√’ indicator is shown to mark the enabled satellites. They will be displayed in the table, as shown in the

Figure 2-27.

Figure 2-27

Press key (ESC) to exist, one dialog box will appear: Are you sure to save the changes? Select ‘YES’ to save

and ‘NO’ to exit without saving.

NOTE: In Dish Align and CH INFO Setup function, you can switch the satellites in enable satellite list quickly.