User Guide

To have the DISH remote control learn specic

commands for another device, complete the following

steps.

Ensure the DISH remote control is working with the

receiver (see page 4 or 5).

Place both the DISH remote and the original

device’s remote control on a at, stable surface.

Point the front of the original device’s remote to face

the small square (IR window) on the front, left-hand

side of the DISH remote, as shown below. The

remotes should be no more than 3” apart.

On the DISH remote, press and hold the Mode

button you want to use for the device until all

the Mode buttons light up (approximately three

seconds), and then release it. The selected Mode

button ashes continuously.

To start learning commands for this mode, select

one of the following choices:

• If you’ve found a code for the device and

programmed it into the remote, press and

release RECALL (the Mode light goes off

when RECALL is pressed and comes on when

released), then hold the RECORD button until

the Mode button is lit again (about three seconds).

The Mode button remains lit while learning.

• If the device code has not been programmed for

that device or if you are unable to nd a code,

press and hold the RECORD button until

the Mode button is lit (about three seconds). The

button remains lit while learning.

Learning from Another

Device’s Remote, continued