User Guide

Learning from Another

Device’s Remote, continued

On the DISH remote, press and release

the button you want the DISH remote to learn from

the original device’s remote. The Mode light goes off

and comes back on.

On the original device’s remote control, press and

hold the button you want learned until the Mode

light goes out and comes back on. You may need

to press and hold the button on the original remote

several times before the DISH remote learns the

command.

• If the DISH remote learns the command, the

Mode light ashes off and then back on.

• If the Mode light ashes three times or remains lit,

the DISH remote did not learn the command.

After a button has learned a command successfully,

repeat step 5 and step 6 until all commands you

want have been learned.

Press and release one of the Mode buttons on the

DISH remote to end the learning sequence. This

saves all the commands for that mode and exits

learning to return to normal remote control operation.

To cancel learning, do not press any buttons on

either remote control for at least 20 seconds. The

DISH remote control times out and returns to normal

operation.

Note: If the remote control batteries are too low

for learning, all the Mode buttons blink quickly

eight times. Learning ends without saving learned

commands, and the remote returns to normal

operation. Change the batteries and begin learning

again.

Note: No learned commands are saved if the DISH

remote control times out before completion.