User Guide

13
Programming Remote to
Control Another Device
Scanning the Remote Database
Turn the device and receiver on.
Press and hold the correct Mode
button for the device until all Mode
buttons light up. Release the
Mode button. The Mode button
ashes. If programming TV or
DVD Mode buttons, go to step 4.
If programming AUX Mode button,
continue to step 3.
For AUX Mode only. Press
— 0 for second TV
— 1 for second DVD/VCR/BD
— 2 for tuner, amplier, or
audio receiver
Press the STAR button
Press POWER.
Pointing the remote at the device
the entire time, press and release
UP ARROW slowly. The Mode
button light goes out and comes
back on. When the device turns
off, continue to step 6. If the device
remains on, continue pressing UP
ARROW. When all codes have been
tried, the Mode button ashes eight
times. Try Learning From Another
Device’s Remote on page 24.
Press POUND (#). The Mode
button ashes three times.
Turn the device on and try other
buttons to make sure the device
responds the way you expect. If
not, try another code by returning
to step 1.
1
2
3
4
5
6
7
Note: Only use Scanning the Remote Database if
you are unable to nd a code using Entering a Code.
This procedure can take several minutes.