User Guide

23
Programming Remote to Control
Second Receiver in AUX Mode
If you have another DISH receiver installed,
you can use this remote control in AUX mode
to operate your new receiver. AUX mode uses
only IR signals, so the line of sight to the second
receiver must be unobstructed. You can program
the remote control to operate any other DISH
receiver except where UHF is used, such as
TV2 on DISH receivers.
Turn on the second receiver
and open System Info
screen.
Write down the TV1 address
that is shown.
Press and hold AUX until all
Mode buttons light up, then
release the button. AUX
ashes.
Use the Number Pad on the
remote control to enter a 3,
followed by the address in
step 2.
Press POUND (#). AUX
ashes three times.
Press RECORD to verify
that the address in the
remote control now matches
the address for the receiver.
1
2
3
4
5
6
1