User Guide

28
Changing the Remote and
Receiver Address
Sometimes the receiver picks up UHF
interference from another receiver in the house
or even a neighbor’s. If you notice that your
receiver is changing channels or opening
menus but you’re not using the remote control,
changing the address should x the problem.
Press SYSTEM INFO on
the receiver’s front panel.
Write down the TV2
remote address shown on
the System Info screen.
Press and hold SAT on
your remote control for
about three seconds, until
all the Mode buttons light
up, and then release SAT.
Add one to the address
that you wrote down
in step 1, and use the
NUMBER PAD to enter
that number (between 1
and 28).
Press POUND (#).
Press RECORD.
Press several buttons on
the remote to make sure
it is working as expected.
1
2
3
4
5
6
7