User Guide

Chapter 9
54
Operating Other Devices
Confirming Remote Control Operation
1 Make sure the remote has fresh batteries and is in SAT mode.
2 Press SYSTEM INFO on the receiver front panel to display the system information screen.
3 Press RECORD on the remote control:
• The Remote Address in the System Info screen changes to match the address preset
in your remote control.
4 Press POWER on the remote control to turn on/off receiver.
OPERATING OTHER DEVICES
To use the remote control to operate other devices (such as a TV, VCR, DVD player, tuner,
amplifier, or DISH antenna), you must first program it to operate these other devices. You
can do this by either following the instructions in Programming Using Device Code Tables
or the Programming Using Device Codes Scan procedure.
Remote Control Modes
Use the remote control’s mode buttons, SAT (satellite receiver or dish antenna), TV (for a
TV), DVD (for a VCR or a DVD/Blu-ray Disc™ player), and AUX (“auxiliary,” for a second
TV, a VCR or disc player, a tuner, an audio amplifier, or a second DISH antenna) to set the
remote to the correct mode for the device. To change the mode, press the button for the
device you want the remote to operate. The mode button lights for two seconds to show
you have set the remote to that mode.
Limited Mode
You can program your remote control in Limited Mode to keep from accidentally changing
the channel on your TV or VCR and causing a snowy or blue screen. When the remote
control is in Limited Mode for TV mode, you will only be able to use POWER, MUTE, and
VOLUME functions for your TV. When the remote control is in Limited Mode for VCR
mode, you will only be able to use POWER and the VCR functions for your VCR.
Note: Limited Mode is not used with amplifiers.
1
2
3
4
Check batteries
and press
SAT Mode
If no operation,
press SYSTEM INFO
on the receiver to
display the System
Info Screen
Press
RECORD
Press
POWER