User Guide

Connections
101
Using Troubleshooting Tools
Point Dish and Check Switch
The Point Dish and Check Switch screens are helpful to the Customer Service
Representatives. You may be asked to display these screens when you call DISH. Even
though there are items that can be changed, only change them when specifically directed
by a Customer Service Representative.
Warning: Running the Check Switch test while the receiver has low or no signal
results in incorrect receiver settings and causes you to lose channels. Do not run
a Check Switch test unless directed by a Customer Service Representative or
other DISH instructions.
1 Press MENU.
2 Select System Setup.
3 Select Installation.
4 Select Point Dish. This screen shows you information to help maximize your satellite
signal. The bar at the bottom of the screen tells you the signal strength. Green is a good
signal, yellow is a marginal signal, and red indicates the signal is not acceptable or is from
the wrong satellite.
1
2
3
4
Press MENU
Select
System Setup
Select
Installation
Select
Point Dish
MENU
System Setup
6
Installation
1
Point Dish
1