User Guide

Operating Other Devices

Chapter 10

3 Press the PLUS side of the VOLUME button.

4 Press 0.

5 Press POUND (#). The TV button flashes three times.

To confirm the VOLUME buttons are operating the TV’s volume control, press SAT and

then try adjusting the volume. The TV’s volume should change.

Programming to Control a Second Satellite Receiver

If you have a second DISH satellite receiver installed, you can use this remote in AUX

mode to operate your other receiver in addition to operating this receiver. When you

program the remote to operate the other receiver, the remote sends out IR signals to the

receiver so the line of sight to the second receiver must be unobstructed. You can program

the remote control to operate any other DISH receiver, except where UHF is used, such as

TV2 on DISH receivers.

1 Turn on the other receiver and display the System Info screen as described in that user’s

guide.

Write down the remote control address:

2 Press and hold AUX until all the other mode buttons light up, and then let go of the button.

AUX flashes.

3 Press the 3 button.

4 Use the NUMBER PAD to enter the address you wrote in step 1.

5 Press POUND (#). AUX blinks three times.

6 Press RECORD to ensure the address in the remote matches the address on the receiver.

Press and hold the

AUX Mode button until all

Mode buttons light up

(AUX flashes)

Display System Info

screen and note the

Remote Control Address

Press the

3 button

AUX

Enter remote

address from

Step 1

Press POUND

(AUX flashes

three times)

Press

RECORD