Quick Start Guide

DN001877
Modem Installation Instructions
Shut down the computer that the modem
is connected to.
Connect that Transmit cable to the TX port on the
replacement modem (indicated by the mark).
Unplug the modem power supply from the
power source.
1
3b
Connect that Receive cable to the RX port
on the replacement modem (indicated by
the mark ).
4b
2
3a
Note: To avoid non-return charges (up to $150 per modem) please return all DISH Network Equipment within 10 days.
QUESTIONS? Contact DISH Network at 1-800-333-DISH (3474). Thank you for your cooperation.
Shut down
Plug the power connector from
the replacement power supply
into the modem. Plug the power
supply into an AC outlet.
6 7
4a
Unplug the Receive cable (indicated by the
mark) from the RX port on the existing modem.
5
9
10
12
11
Unplug the Ethernet cable from the
Ethernet port on the existing modem.
13
Restart the computer.
Launch the Internet browser.
Do not reconnect the Ethernet
Cable to the new modem at this time.
NOTE:
Once your power supply is plugged into an AC outlet, the power light on the
modem will come on and the receive indicator light will start blinking. Once
the modem locks onto the signal, the receive indicator light will remain solid.
8
Connect the Ethernet cable from your PC
to the Ethernet port on the replacement
modem.
This process can take up to 4 hours. After your modem has locked,
continue to next step.
NOTE:
Select the Submit button.
Select the Replace button.
Unplug the Transmit cable (indicated by the
mark) from the TX port on the existing modem.
The receive indicator light
Power light
Enter the Username and Password
used when your WildBlue system
was installed and activated.
If you do not have this Username
and Password, please call
1-800-333-DISH (3474).