User Guide

10
4. On the UHF Pro remote control that came with the kit, press
and hold the SAT mode button for three seconds until all
mode buttons light. Then, let go.
5. Use the NUMBER PAD buttons to enter the number you wrote in
step 3.
6. Press the POUND (#) button.
If you entered the address
correctly, the SAT mode button will flash three times.
USING THE REMOTE CONTROL
After you have installed the converter and set up your UHF Pro remote
control, make sure that the remote can control your receiver in the
same room and also from other places where you want to use the
remote control. If the remote cannot control the receiver, see
Troubleshooting the Kit on page 42.
REMOTE CONTROL OPERATION
This section describes how to use the remote control that came with the
kit.
CHANGING THE RECEIVER AND REMOTE CONTROL
ADDRESSES
1. Open the System Information screen. Consult your receiver user's
guide for instructions on how to open this screen without using the
remote control. The System Information screen will show either
one
Remote Address, or it may show a Primary Remote Address
and a Secondary Remote Address.
Note: On the DISH Player-DVR 522 and DISH 322, program the
remote control on TV1 only.
2. Press and hold the SAT mode button about three seconds,
until all the mode buttons light up, and then let go of the
SAT button. The SAT mode button will blink.
3. Use the NUMBER PAD buttons to enter any number from 1 to 16.
The SAT mode button goes out after you enter each digit, and then
lights up again.
Write down the number you entered: __________
Note: If using more than one UHF Pro remote control in your
house, make sure that the remote controls are set to different
addresses from each other.
4. Press the POUND (#) button. If you entered the address
correctly, the SAT mode button will flash three times.
Pyramid.book Page 10 Wednesday, February 16, 2005 4:00 PM