User Guide

5. Press the RECORD button.

6. Make sure the

System Information screen shows the

address number you entered in step 3.

7. Close the

System Information screen. On most

receivers, this is done by selecting

Done. See your receiver user's

guide for more information.

CHECKING THE REMOTE CONTROL ADDRESS

To check the remote control address setting:

1. Press and hold the SAT mode button for three seconds

until all mode buttons light. Then, let go.

2. Press the POUND (#) button twice while watching the

SAT mode button.

3. Count the number of times the SAT mode button flashes.

This number is the remote address. For example, if the

SAT mode button flashes 6 times, this indicates the

remote address is set to 6.

SETTING UP TO CONTROL OTHER DEVICES

To use the remote to control other devices (such as a TV, VCR, DVD

player, tuner/amplifier, or a second DISH Network satellite receiver),

you must first program it to control these other devices. You can do this

by either following the instructions in Setting Up Using Device Code

Tables on page 12, or the Setting Up Using Device Codes Scan

procedure described on page 13.

COMBINATION DEVICES

If you are programming the remote to control a combination device,

such as a TV/VCR or a TV/DVD, program the remote control in one

mode, and then repeat the procedure in the other mode. For example, to

program the remote to control a TV/VCR using code 748, follow the

instructions to program the remote to control the TV using code 748,

and then repeat the instructions for the VCR using the same code.

LIMITED MODE

You can program your remote control in Limited Mode to keep from

accidentally changing the channel on your TV or VCR. When you use

the remote to control your TV in Limited Mode, you will only be able

to use the POWER, MUTE, and VOLUME buttons to control your TV.

Pyramid.book Page 11 Wednesday, February 16, 2005 4:00 PM